Cisco RV110W - Editing Snmpv3 Users

Administering Your Cisco RV110W
Configuring Simple Network Management (SNMP)
Cisco RV110W Administration Guide 120
7
To enable SNMP:
STEP 1 Choose Administration > SNMP.
STEP 2 Check Enable to enable SNMP.
STEP 3 Enter this information:
STEP 4 Click Save.
Editing SNMPv3 Users
You can configure SNMPv3 parameters for the two default Cisco RV110W user
accounts (Admin and Guest).
To configure SNMPv3 settings:
STEP 1 Choose Administration > SNMP.
STEP 2 Under SNMPv3 User Configuration, configure the following settings:
SysContact Enter the name of the contact person for this
firewall (for example, admin or John Doe.)
SysLocation Enter the physical location of the firewall (for
example, Rack #2, 4th Floor.)
SysName Enter a name for easy identification of the firewall.
UserName Select the account to configure (admin or guest).
Access Privilege Displays the access privileges of the selected user
account.