Configuring the Firewall
Configuring Access Rules
Cisco RV110W Administration Guide 86
4
To create a custom service:
STEP 1 Choose Firewall > Service Management.
STEP 2 Click Add Row.
STEP 3 In the Service Name field, enter the service name for identification and
management purposes.
STEP 4 In the Protocol field, choose the Layer 4 protocol that the service uses from the
drop-down menu:
• TCP
• UDP
• TCP & UDP
• ICMP
STEP 5 In the Start Port field, enter the first TCP or UDP port of the range that the service
uses.
STEP 6 In the End Port field, enter the last TCP or UDP port of the range that the service
uses.
STEP 7 Click Save.
To edit an entry, select the entry and click Edit. Make your changes, then click
Save.
Configuring Access Rules
Configuring the Default Outbound Policy
The Access Rules page allows you to configure the default outbound policy for
the traffic that is directed from the secure network (LAN) to the non-secure
network (dedicated WAN/optional).
The default inbound policy for traffic flowing from the non-secure zone to the
secure zone is always blocked and cannot be changed.