Configuring the Firewall
Configuring Basic Firewall Settings
Cisco RV110W Administration Guide 84
4
CAUTION When remote management is enabled, the router is accessible to anyone who
knows its IP address. Because a malicious WAN user can reconfigure the
Cisco RV110W and misuse it, it is highly recommended that you change the
administrator and any guest passwords before continuing.
Configuring Universal Plug and Play
Universal Plug and Play (UPnP) allows automatic discovery of devices that can
communicate with the Cisco RV110W.
To configure UPnP, configure these settings on the Basic Settings page:
Remote Management
Port
Enter the port on which remote access is allowed.
The default port is 443. When remotely accessing
the router, you must enter the remote management
port as part of the IP address. For example:
https://<
remote-ip
>:<
remote-port
>, or https://
168.10.1.11:443
UPnP Check Enable to enable UPnP.
Allow Users to Configure Check this box to allow UPnP port-mapping rules
to be set by users who have UPnP support enabled
on their computers or other UPnP enabled devices.
If disabled, the Cisco RV110W does not allow
application to add the forwarding rule.
Allow Users to Disable
Internet Access
Check this box to allow users to disable Internet
access.