Viewing the Cisco RV110W Status
Viewing Logs
Cisco RV110W Administration Guide 144
8
• Duration—Displays the elapsed time for which the connection is or was
active.
• Packet—Displays the received (Rx) and transmitted (Tx) packets on the
connection.
• Byte—Displays the received (Rx) and transmitted (Tx) bytes on the
connection.
• State—Displays the state of the connection (for example, active or not
connected).
• Action—Displays actions you can perform on the connection (for example,
disconnect).
STEP 3 If you made any changes, click Save.
Viewing Logs
The View Logs page allows you to view the Cisco RV110W logs.
To view the logs:
STEP 1 Choose Status > View Logs.
STEP 2 Click Refresh Logs to display the latest log entries.
STEP 3 To filter logs, or specify the severity of logs to display, check the boxes next to the
log type and click Go. Note that all log types above a selected log type are
automatically included and you cannot deselect them. For example, choosing
“error” logs automatically includes emergency, alert, and critical logs in addition to
error logs.
The event severity levels are listed from the highest severity to the lowest severity,
as follows:
• Emergency—System is not usable.
• Alert—Action is needed.
• Critical—System is in a critical condition.
• Error—System is in error condition.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
