Configuring Networking
Configuring the IP Mode
Cisco RV110W Administration Guide 44
2
STEP 5 To test the DDNS configuration, click Test Configuration.
STEP 6 Click Save.
Configuring the IP Mode
Wide area network configuration properties are configurable for both IPv4 and
IPv6 networks. You can enter information about your Internet connection type and
other parameters in these pages.
To select an IP mode:
STEP 1 Choose Networking > IP Mode.
STEP 2 From the IP Mode drop-down menu, choose one of the following options:
Password Enter the password of the DDNS account.
Verify Password (TZO.com, DynDNS.com, and noip.com) Reenter
the password of the DDNS account.
Host Name (DynDNS.com, 3322.org, and noip.com) Enter the
host name of the DDNS server.
Domain Name (TZO.com) Enter the name of the domain that is
used to access the network.
Internet IP Address (Read-only) The Internet IP address of the
Cisco RV110W.
Status (Read-only) Status is displayed if the DDNS update
has completed successfully or if the account
update information sent to the DDNS server failed.
LAN:IPv4, WAN:IPv4 Choose this option to use IPv4 in the LAN and WAN
ports.
LAN:IPv6, WAN:IPv4 Choose this option to use IPv6 in the LAN ports and
IPv4 in the WAN ports.