Cisco RV110W - Configuring Static IP; Configuring Pppoe

Configuring Networking
Configuring the WAN Settings
Cisco RV110W Administration Guide 23
2
STEP 3 (Optional) To configure the optional settings, see Configuring Optional Settings.
STEP 4 Click Save.
Configuring Static IP
If your ISP assigned you a permanent IP address, perform the following steps to
configure your WAN settings:
STEP 1 Choose Networking > WAN.
STEP 2 From the Internet Connection Type drop-down menu, choose Static IP.
STEP 3 Enter this information:
STEP 4 (Optional) To configure the optional settings, see Configuring Optional Settings.
STEP 5 Click Save.
Configuring PPPoE
To configure the PPPoE settings:
STEP 1 Choose Networking > WAN.
STEP 2 From the Internet Connection Type drop-down menu, choose PPPoE.
STEP 3 Enter the following information (you may need to contact your ISP to obtain your
PPPoE login information):
Internet IP Address Enter the IP address of the WAN port.
Subnet mask Enter subnet mask of the WAN port.
Default Gateway Enter the IP address of the default gateway.
Static DNS 1 Enter the IP address of the primary DNS server.
Static DNS 2 Enter the IP address of the secondary DNS server.