Cisco RV110W - Configuring Optional Settings

Configuring Networking
Configuring the WAN Settings
Cisco RV110W Administration Guide 28
2
STEP 4 (Optional) To configure the optional settings, see Configuring Optional Settings.
STEP 5 Click Save.
Configuring Optional Settings
To configure optional settings:
STEP 1 In the Optional Settings section, configure the following settings:
Keep alive When you select this option, the Internet
connection is always on. In the redial period field,
enter the number of seconds after which the
Cisco RV110W attempts to reconnect if it is
disconnected.
Authentication Type Choose the authentication type:
Auto-negotiation—The server sends a
configuration request specifying the security
algorithm set on it. Then, the Cisco RV110W sends
back authentication credentials with the security
type sent earlier by the server.
PAP—The Cisco RV110W uses the Password
Authentication Protocol (PAP) to connect to the ISP.
CHAP—The Cisco RV110W uses the Challenge
Handshake Authentication Protocol (CHAP) when
connecting with the ISP.
MS-CHAP or MS-CHAPv2—The Cisco RV110W
uses Microsoft Challenge Handshake
Authentication Protocol when connecting with the
ISP.
Host Name Enter the host name of the Cisco RV110W.
Domain Name Enter the domain name for your network.