Cisco RV110W - Page 14

Introduction
Connecting the Equipment
Cisco RV110W Administration Guide 14
1
STEP 3 Connect one end of a different Ethernet cable to one of the LAN (Ethernet) ports on
the back of the unit. (In this example, the LAN 1 port is used.) Connect the other
end to an Ethernet port on the PC that you will use to run the web-based Setup
Wizard and Device Manager.
STEP 4 Power on the cable or DSL modem and wait until the connection is active.
STEP 5 Connect the power adapter to the Cisco RV110W power port (12VDC).
!
CAUTION Use only the power adapter that is supplied with the unit. Using a different power
adapter could damage the unit.