Configuring the Wireless Network
Configuring Basic Wireless Settings
Cisco RV110W Administration Guide 72
3
STEP 6 Choose the VLAN you created for the guest network (or, if you have not yet
created a network, select Add New VLAN).
STEP 7 Click Save. The system notifies you that the physical Ethernet ports on the
Cisco RV110W are excluded from the VLAN that you have assigned to the guest
network. In addition, Wireless Isolation with SSID and WMM are automatically
enabled.
Configure the Password and Other Options
STEP 1 In the Management Interface, choose Wireless > Basic Settings.
STEP 2 Under the
Wireless Table
, click Edit Guest Net.
STEP 3 Enter a password that users will enter to access the guest network.
STEP 4 Enter the password again to confirm.
STEP 5 Enter the time, in minutes, that the guest connection will be available for users.
STEP 6 (Optional) To restrict bandwidth usage by the guest network, check
Enable Guest
Bandwidth Restriction
. (QoS must be enabled first; click the link to the Bandwidth
Management page if you need to configure QoS.) In the
Available Bandwidth
field,
enter the percentage of bandwidth to allocate to the guest network.
STEP 7 Click Save.
To Next Page
Loading...
