Configuring Virtual Private Networks (VPNs) and Security
Configuring Advanced VPN Parameters
Cisco RV120W Administration Guide 105
5
The Active IPsec SAs table displays a list of active IPsec SAs. Table fields are as
follows:
Configuring VPN Users
To view a list of VPN users, choose VPN > IPsec > VPN Users. The VPN gateway
authenticates users in this list when XAUTH is used in an IKE policy. QuickVPN
clients can access only default LAN hosts.
Configuring a PPTP Server
If you are using a Point-to-Point Tunneling Protocol VPN server:
STEP 1 Choose VPN > IPsec > VPN Users.
STEP 2 Under PPTP Server, check the Enable box.
STEP 3 Enter the IP address of the PPTP server.
STEP 4 In the Starting IP Address field, enter the starting IP address of the range of IPs to
assign to connecting users.
STEP 5 In the Ending IP Address field, enter the ending IP address of the range of IPs to
assign to connecting users.
Field Description
Policy Name IKE or VPN policy associated with this SA.
Endpoint IP address of the remote VPN gateway or client.
Packets Number of IP packets transmitted over this SA.
Kbytes Kilobytes of data transmitted over this SA.
State Status of the SA for IKE policies: Not Connected or
IPsec SA Established.
Action Choose Connect to establish a connection, or Drop
to terminate an established connection.