Configuring Quality of Service (QoS)
Configuring CoS Settings
Cisco RV120W Administration Guide 115
6
STEP 5 Depending on the traffic selector you chose, enter this information:
STEP 6 Click Save.
Configuring CoS Settings
You can map CoS priority settings to the traffic forwarding queue on the RV120W.
To map CoS priority settings to the traffic forwarding queue:
STEP 1 Choose QoS > CoS Settings > Cos Settings.
STEP 2 In the CoS to Queue field, check Enable.
STEP 3 For each CoS priority level in the CoS to Traffic Forwarding Queue Mapping
Table, choose a priority value from the Traffic Forwarding Queue drop-down
menu.
These values mark traffic types with higher or lower traffic priority depending on
the type of traffic.
STEP 4 Click Save.
Starting IP Address Enter the starting IP address of the range.
Ending IP Address Enter the ending IP address of the range.
MAC Address Enter the MAC address for any client device (for
example, a PC or wireless client) to which you want
to assign the bandwidth.
VLAN ID Choose the VLAN ID on the router to which the
traffic selector applies.
DSCP Value Enter the Differentiated Services Code Point
(DSCP) value (0–63).
This value determines how the traffic is prioritized.
Available SSIDs Choose the SSID the selector applies to from the
drop-down menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
