Cisco RV120W - Chapter 2: Configuring Networking; Configuring the WAN (Internet) Settings

2
Cisco RV120W Administration Guide 19
Configuring Networking
The networking page allows you to configure networking settings. This chapter
contains the following sections:
• Configuring the WAN (Internet) Settings, page 19
• Configuring the LAN (Local Network) Settings, page 27
• Configuring Routing, page 34
• Configuring Port Management, page 40
• Configuring Dynamic DNS (DDNS), page 40
• Configuring IPv6, page 42
NOTE Cisco recommends you use the Setup Wizard to configure basic networking on the
Cisco RV120W. You can then make changes and provision advanced features using
the Device Manager.
Configuring the WAN (Internet) Settings
If you have an IPv4 network, use these sections to configure your network. If you
have an IPv6 network, see Configuring IPv6, page 42.