Cisco RV120W - Configuring Remote Logging

Administering Your Cisco RV120W
Configuring Logging
Cisco RV120W Administration Guide 128
7
will be dropped and a message will be logged. (Make sure the log option is
set to allow for this firewall rule.)
STEP 3 Under the type of system logs, select the type of system events to be logged. The
following system events can be recorded:
• All Unicast Traffic—Check this box to log all unicast packets directed to the
router.
• All Broadcast/Multicast Traffic—Check this box to log all broadcast or
multicast packets directed to the router.
STEP 4 Under “other events logs,” select the type of event to be logged. The following
events can be recorded:
• Source MAC Filter—Check this box to log packets matched due to source
MAC filtering. Uncheck this box to disable source MAC filtering logs.
• Bandwidth Limit—Check this box to log packets dropped due to Bandwidth
Limiting.
STEP 5 Click Save.
Configuring Remote Logging
To configure remote logging:
STEP 1 Choose Administration > Logging > Remote Logging Configuration.
STEP 2 In the Remote Log Identifier field, enter a prefix to add to every logged message
for easier identification of the source of the message. The log identifier will be
added to both e-mail and Syslog messages.
STEP 3 Click Save.