Cisco RV120W - Chapter 6: Configuring Quality of Service (Qos); Configuring WAN Qos Profiles

6
Cisco RV120W Administration Guide 112
Configuring Quality of Service (QoS)
The Cisco RV120W lets you configure the following Quality of Service (QoS)
features:
• Configuring WAN QoS Profiles, page 112
• Configuring Profile Binding, page 114
• Configuring CoS Settings, page 115
• Mapping CoS Settings to DSCP Values, page 116
Configuring WAN QoS Profiles
WAN QoS profiles let you manage the bandwidth of the traffic flowing from the
secure network (LAN) to the insecure network (WAN).
You can configure WAN QoS profiles to control the rate at which the RV120W
transmits data. For example, limiting the outbound traffic helps you prevent the
LAN users from consuming all of the bandwidth of the Internet link.
Configuring Global Settings
To configure the WAN QoS global settings:
STEP 1 Choose QoS > WAN QoS Profiles.
STEP 2 Under Global Settings:
a. To enable WAN QoS, check Enable.
b. Set the WAN QoS mode by clicking the Priority or Rate Limit radio button.
The Priority option lets you allocate bandwidth based on a priority level.
The Rate Limit option lets you specify the total WAN bandwidth (1–100 Mbps).