Chapter 9 Troubleshooting
Recovery Procedures
9-18
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
ip default-gateway 172.20.153.01
hostname host_name
enable secret 5 $1$M3pS$cXtAlkyR3/6Cn8/
line vty 0 15
password telnet_password
snmp community private rw
snmp community public ro
cluster enable cls_name
end
Step 22 Verify that the information is correct.
• If the information is correct, enter Y at the prompt, and press Return.
• If the information is not correct, enter N at the prompt, press Return, and
begin again at Step 1.
Use this configuration? [yes/no]: y
Step 23 Start your browser, and enter the switch IP address that you entered in Step 11.
Step 24 Display the VSM Home page for the switch, and select Enabled from the
Command Switch drop-down list.
Step 25 Click Cluster Management, and display Cluster Builder.
CMS prompts you to add candidate switches. The password of the failed
command switch is still valid for the cluster, and you should enter it when
candidate switches are proposed for cluster membership.
To Next Page
Loading...
Need help?
General