9-21
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
78-6511-05
Chapter 9 Troubleshooting
Recovery Procedures
Step 16 Assign a name to the cluster, and press Return.
Enter cluster name: cls_name
Note The cluster name can be 1 to 31 alphanumeric characters, dashes, or
underscores.
Step 17 The initial configuration is displayed:
The following configuration command script was created:
ip subnet-zero
interface VLAN1
ip address 172.20.153.36 255.255.255.0
ip default-gateway 172.20.153.01
hostname host_name
enable secret 5 $1$M3pS$cXtAlkyR3/6Cn8/
line vty 0 15
password telnet_password
snmp community private rw
snmp community public ro
cluster enable cls_name
end
Step 18 Verify that the information is correct.
• If the information is correct, enter Y at the prompt, and press Return.
• If the information is not correct, enter N at the prompt, press Return, and
begin again at Step 1.
Use this configuration? [yes/no]: y
Step 19 Start your browser, and enter the switch IP address that you entered in Step 7.
Step 20 Click Cluster Manager Suite or Visual Switch Manager, and display Cluster
Builder.
It prompts you to add the candidate switches. The password of the failed
command switch is still valid for the cluster. Enter it when candidate switches are
proposed for cluster membership, and click OK.
To Next Page
Loading...
Need help?
General