Firmware 5-39
Description
The rmc command allows you to invoke the remote management console (RMC)
from a VGA monitor connected to the VGA port.
After entering the rmc command, type the default escape sequence to connect to
the RMC. The default escape sequence is:
^[^[rmc
This sequence is equivalent to Ctrl/left bracket, Ctrl/left bracket, rmc. On some
keyboards, the escape key functions like the Ctrl/left bracket combination.
The console environment variable must be set to graphics, and the serial in-
terface cannot be in use by another console program. Once you have connected
to RMC, the serial interface is disabled. See Example 5–18 for an example of an
unsuccessful connection and a successful connection.
To exit RMC, enter the RMC reset command or press the Reset button on the
control panel. The reset disconnects the RMC session, resets hardware, and
reloads the SRM console from the flash ROM.
See Chapter 6 for complete information about the RMC.
To Next Page
Loading...
Need help?
General
