Operation 2-25
2.5 Setting SRM Environment Variables
You may need to set several SRM console environment variables and
built-in utilities to configure the system.
Set environment variables at the P00>>> prompt.
• To check the setting for a specific environment variable, enter the show
envar command, where the name of the environment variable is sub-
stituted for envar. To see a list of the environment variables, enter the
show* command.
• To reset an environment variable, use the set envar command, where the
name of the environment variable is substituted for envar.
The environment variables used to set up the boot environment are described in
Chapter 3. Chapter 5 covers other environment variables you are likely to use.
To Next Page
Loading...
