Firmware 5-17
5.5.2 Displaying the Bootable Devices
Use the show device command to display the bootable devices.
Example 5–3 Show Device
P00>>> show device
dka0.0.0.1.1 DKA0 RZ2DD-LS 0306
dka100.1.0.1.1 DKA100 RZ2DD-LS 0306
dka200.2.0.1.1 DKA200 RZ1CB-CS 0844
dkb0.0.0.3.1 DKB0 RZ25 0900
dqa0.0.0.15.0 DQA0 TOSHIBA CD-ROM XM-6302B 1012
dva0.0.0.1000.0 DVA0
ewa0.0.0.4.1 EWA0 00-00-F8-09-90-FF
ewb0.0.0.2002.1 EWB0 00-06-2B-00-25-5B
pka0.7.0.1.1 PKA0 SCSI Bus ID 7
pkb0.7.0.3.1 PKB0 SCSI Bus ID 7
pkc0.7.0.2000.1 PKC0 SCSI Bus ID 7
pkd0.7.0.2001.1 PKD0 SCSI Bus ID 7
Table 5–8 Device Naming Conventions
Category Description
dq
Driver ID Two-letter designator of port or class driver
dk SCSI drive or CD ew Ethernet port
dq IDE CD-ROM fw FDDI device
dr RAID set device mk SCSI tape
du DSSI disk mu DSSI tape
dv Diskette drive pk SCSI port
ei Ethernet port pu DSSI port
pz KZPCC-CE RAID
controller
df
Disk test Tests the df disk (read only)
a
Storage adapter ID One-letter designator of storage adapter
(a, b, c…).
0
Device unit number Unique number (MSCP unit number). SCSI unit
numbers are forced to 100 X node ID.
0
Bus node number Bus node ID.
0
Channel number Used for multi-channel devices.
15
Logical slot num. Corresponds to PCI slot number (see Table 5–6).
0
Hosenumber 0—PCI0 1—PCI1
2—PCI2 3—PCI3
To Next Page
Loading...
Need help?
General
