Compaq AlphaServer ES45 1B User Manual

Remote Management 6-27
6.8 RMC Command Reference
This section describes the RMC command set. Commands are listed in
alphabetical order.
clear {alert, port}
dep
disable {alert, remote}
dump
enable {alert, remote}
env
halt {in, out}
hangup
help or ?
power {on, off}
quit
reset
send alert
set {alert, com1_mode, dial, escape, init, logout, password, user}
status
NOTE: The dep and dump commands are reserved for service providers.
clear alert
The clear alert command clears the current alert condition and causes the
RMC to stop paging the remote system operator.
If the alert is not cleared, the RMC continues to page the remote operator every
30 minutes if the dial-out alert feature is enabled.
The clear alert command clears the current alert so that the RMC can capture
a new alert. The last alert is stored until a new event overwrites it. The Alert
Pending field of the status command becomes NO after the alert is cleared.
RMC> clear alert
RMC>

Compaq AlphaServer ES45 1B Specifications

General

Processor Speed	1 GHz
Memory	Up to 32 GB
Memory Type	DDR SDRAM
Expansion Slots	6 PCI slots
Network	Integrated 10/100 Ethernet
Operating System	Tru64 UNIX, OpenVMS
Form Factor	Rackmount
Processor	Alpha EV68
Chipset	Tsunami chipset
Storage	Up to 6 hot-swap SCSI drives
I/O Slots	6 PCI slots
Power Supply	Redundant hot-swap power supplies

Summary

Operation

Powering Up the System

Provides steps to power on the AlphaServer ES45 system.

SRM Console

Introduction to the SRM command-line interface for system management.

Setting Console Security

Procedures for setting console passwords and secure mode.

Updating Firmware

Methods for updating system firmware via CD-ROM or network.

Booting and Installing an Operating System

Setting Boot Options

Configuring boot devices, flags, and network protocols via SRM.

Starting a Tru64 UNIX Installation

Procedure for installing the Tru64 UNIX operating system.

Configuring and Installing Components

Before Installing Components

Prerequisites and safety precautions before installing components.

Removing and Replacing Power Supplies

Procedure for removing and replacing system power supplies.

Installing CPUs

Step-by-step guide for installing CPU modules.

Memory Configuration

Rules and considerations for memory configuration and DIMM installation.

Installing Universal Hard Disk Drives

Procedure for installing hot-pluggable universal hard disk drives.

Firmware

Invoking the SRM Console

Booting an Operating System

Testing the System

Remote Management

Entering the RMC

Using Power On and Off, Reset, and Halt Functions

Configuring Remote Dial-In

Resetting the RMC to Factory Defaults

Troubleshooting Tips

Troubleshooting

Power-Up Error Messages

No MEM Error

RMC Error Messages

Test Command