Firmware 5-27
5.7 Testing the System
The test command verifies the configuration of the devices in the sys-
tem.
Example 5–11 Test
P00>>> test
Testing the Memory
Testing the DK* Disks(read only)
No DU* Disks available for testing
No DR* Disks available for testing
Testing the DQ* Disks(read only)
Testing the DF* Disks(read only)
No MK* Tapes available for testing
No MU* Tapes available for testing
Testing the DV* Floppy Disks(read only)
Testing the VGA (Alphanumeric Mode only)
Testing the EWA0 Network
Testing the EWB0 Network
P00>>>
Description
The test command also does a quick test on the system speaker. A beep is emit-
ted as the command starts to run.
The tests are run sequentially, and the status of each subsystem test is dis-
played to the console terminal as the tests progress. If a particular device is not
available to test, a message is displayed. The test script does no destructive
testing; that is, it does not write to disk drives.
Syntax
test [argument]
Use the -lb (loopback) argument for console loopback tests.
To Next Page
Loading...
Need help?
General
