Firmware 5-55
Syntax
set com1_mode value
value
through
snoop
soft_bypass
firm_bypass
local
Defined values are:
All data passes through RMC and is filtered for the RMC escape se-
quence. Thisisthedefault.
Data partially bypasses RMC, but RMC taps into the data lines and
listens passively for the RMC escape sequence.
Data bypasses RMC, but RMC switches automatically into snoop mode
if loss of carrier occurs.
Data bypasses RMC. RMC remote management features are disabled.
Changes the focus of the COM1 traffic to the local RMC COM1 port if
RMC is currently in one of the bypass modes or if RMC is in through
mode with an active remote session.
Example
P00>>> set com1_mode snoop
To Next Page
Loading...
