EasyManua.ls Logo

Compaq AlphaServer ES45 1B - Page 267

Compaq AlphaServer ES45 1B
322 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Management 6-29
enable alert
The enable alert command enables the RMC to page a remote system operator.
Before you can enter the enable alert command, you must configure remote
dial-in and call-out, set an RMC password, and enable remote access to the
RMC modem port. See Section 6.6.4 and Section 6.6.5.
RMC> set dial
Dial String: ATXDT9,15085553333
RMC> set alert
Alert String: ,,,,,,5085553332#;
RMC> enable alert
RMC>
If the enable alert command fails, the following error message is displayed:
***ERROR-enablefailed***
Issue the status command to see if the Remote Access field is set to Enabled.

Table of Contents

Related product manuals