Index-5
SRM, 5-65
Power-up procedure, 2-5
Power-up script, creating, 5-36
Problems getting to console mode, 7-21
Problems reported by console, 7-22
Processor card, 1-13
Processor, enabling, 5-58
Program, resuming, 5-31
Q
QLogic controller, 5-71
quit command (RMC), 6-11, 6-33
R
Reading a file, 5-32
Redundant power supply, 4-16
Regulatory approvals, 8-9
Remote power-on/off, 6-18
Removable media, 1-22
Removable media device, installing, 4-44
Removing enclosure panels, 4-3
from a pedestal, 4-6
from a tower, 4-4
Reset button, 1-11
reset command (RMC), 5-39, 6-33
Reset command (RMC), 1-11
Reset, from RMC, 1-11, 6-19
Resetting firmware, 5-33
RIS boot, 3-15
RIS boot procedure, 3-16
RMC
auxiliary power supply, 6-3
bypass modes, 6-6
CLI, 6-13
command conventions, 6-13
configuring call-out, 6-20
data flow diagram, 6-4
dial-out alert, 6-22
entering, 6-11
env command, 6-16
error messages, 7-7
escape sequence, 5-39, 6-11
exiting, 6-11
exiting from local VGA, 6-12
firm bypass mode, 6-8
hangup command, 6-21
local mode, 6-5
logic, 6-3
operating modes, 6-4
overview, 6-2
PIC processor, 6-3
quit command, 6-11
remote power on/off, 6-18
remote reset, 6-19
resetting to factory defaults, 6-25
snoop mode, 6-7
soft bypass mode, 6-7
status command, 6-14
terminal setup, 6-9
through mode, 6-5
troubleshooting, 6-39
rmc command (SRM), 5-38
RMC commands
clear alert, 6-27
clear port, 6-28
disable alert, 6-28
disable remote, 6-28
enable alert, 6-29
enable remote, 6-30
env, 6-30
halt in, 6-31
halt out, 6-31
hangup, 6-31
help or ?, 6-32
power off, 6-32
power on, 6-32
quit, 6-33
reset, 5-39, 6-33
send alert, 6-33
set alert, 6-34
set com1_mode, 6-34
set dial, 6-36
set escape, 6-36
set init, 6-37
set logout, 6-37
set password, 6-38
set user, 6-38
status, 6-38
RMC firmware, updating, 2-36
To Next Page
Loading...
