D-Link DWC-1000

Wireless Controller CLI Reference Guide
123
IPv6 Prefix length
29
general_enable_keepalive
enable/disable keepalive
Boolean choice
30
general_keepalive_sourceip
keepalive sourceip
31
general_keepalive_destinationip
keepalive destinationip
32
general_keepalive_detection_period
keepalive detection period
33
general_keepalive_failure_count
keepalive failure count
34
manual_spi_in
Takes a hexadecimal value betw een
3 and 8 characters.
Takes a hexadecimal value betw een 3
and 8 characters
35
manual_spi_out
Takes a hexadecimal value betw een
3 and 8 characters.
Takes a hexadecimal value betw een 3
and 8 characters
36
manual_encryption_algorithm
The algorithm used to encrypt the
data
vpn encryption algorithm
37
manual_key_length
The key length for the algorithm.
Unsigned integer
38
manual_encryption_key_in
Encryption key of the inbound policy.
The length of the key depends on the
algorithm chosen
String
39
manual_encryption_key_out
Encryption key of the outbound
policy. The length of the key depends
on the algorithm chosen.
String
40
manual_authentication_algorithm
Algorithm used to verify the integrity
of the data.
vpn authentication algorithm
41
manual_authentication_key_in
This is the integrity key (for ESP w ith
Integrity-mode) for the inbound policy
and depends on the algorithm
chosen
String
42
manual_authentication_key_out
This is the integrity key (for ESP w ith
Integrity-mode) for the outbound
policy and depends on the algorithm
chosen
String
43
auto_phase1_exchange_mode
Setting IKE exchange Mode
VPN Exchange Mode
44
auto_phase1_enable_nat_traversal
Enabling/Disabling Nat traversal
Boolean choice
45
auto_phase1_nat_keepalive_frequecy
Setting IKE nat alive frequency
Unsigned integer
46
auto_phase1_local_identtype
Setting IKE local identifier type
IPsec VPN IKE local identifier type
47
auto_phase1_direction_type
Setting IKE direction type
IPsec VPN IKE direction Mode
48
auto_phase1_local_identifier
Setting IKE local identifier
String
49
auto_phase1_remote_identtype
Setting IKE remote identifier
IPsec VPN IKE local identifier type
50
auto_phase1_remote_identifier
Setting IKE remote identifier
String
51
auto_phase1_encryption_algorithm
Setting IKE encryption algorithm
IPsec VPN IKE encryption algorithm
type
52
auto_phase1_key_length
The key length for the algorithm.
Unsigned integer
53
auto_phase1_auth_algorithm
Setting IKE authentication algorithm
IPsec VPN IKE authentication
algorithm type
54
auto_phase1_auth_method
Setting IKE authentication algorithm
method
IPsec VPN IKE authentication
algorithm method
55
auto_phase1_dh_group
Setting IKE Diffie-Hellman (DH)