Danfoss iC2 - Page 160

Selection number Selection name
11 Local bus reference
21 Potentiometer
P 5.5.3.8 Reference 2 Source
Use this parameter to select the input for the 2nd reference signal. The parameters P 5.5.3.7 Reference 1 Source, P 5.5.3.8 Reference 2
Source, and P 5.5.3.9 Reference 3 Source define up to 3 different reference signals. The sum of these reference signals defines the actual
reference.
Default value: 2 [Analog Input 34] Parameter type: Selection
Parameter
number:
316 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 No function
1 Analog Input 33
2 Analog Input 34
8 Frequency Input 18
11 Local Bus reference
21 Potentiometer
P 5.5.3.9 Reference 3 Source
Use this parameter to select the input for the 3rd reference signal. P 5.5.3.7 Reference 1 Source, P 5.5.3.8 Reference 2 Source, andP 5.5.3.9
Reference 3 Source define up to 3 different reference signals. The sum of these reference signals defines the actual reference.
Default value: 11 [Local bus reference] Parameter type: Selection
Parameter
number:
317 Unit: –
Data type: enum Access type: Read/Write
The following are the selections for the parameter.
Selection number Selection name
0 No function
1 Analog Input 33
2 Analog Input 34
8 Frequency Input 18
160 | Danfoss A/S © 2024.03 AB413939445838en-000301 / 130R1254
Application Guide | iC2-Micro Frequency Converters