Next steps
1. Follow the procedure listed in After working inside your system.
2. Install any device drivers required for the card as described in the documentation for the card.
Removing the expansion card risers for NVIDIA GPU configuration
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the storage tray.
Steps
1. For Riser 1B and Riser 4B, using a Phillips 2 screwdriver, loosen the blue thumb screw on the riser.
2. Remove the turtle shell.
3. Pull the plunger toward the front of the chassis to unlock the riser.
4. Disconnect any cables that are connected to the expansion card or the risers from the system board.
5. Lift the expansion card riser from the riser connector on the system board and keep it away from the system board.
Figure 105. Removing the expansion card riser (Riser 1B)
Installing and removing system components
127
To Next Page
Loading...
