Figure 114. Installing the lower brace cover
Next steps
1. Install the Storage tray.
2. Reconnect the intrusion switch bridge cable from the storage tray that is connected from the system board. Reconnect the
drive backplane cables, BOSS power and signal cables, fan board cables from the connector of the storage tray.
3. Install the cable cover.
4. Follow the procedure listed in After working inside your system.
.
Removing the lower brace cover for NVIDIA GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove the cable cover.
4. Observe and disconnect the intrusion switch bridge cable from the connectors on the storage tray that is connected from
the system board. Observe and disconnect the drive backplane cables, BOSS power and signal cables, fan board cables from
the connector on the storage tray, signal cable from the connectors on the PDB2 and then keep the cables away from the
storage tray. Disconnect the VSB power cables (left and Right) from the connector on the system board and keep them on
the storage tray.
5. Remove the storage tray.
Steps
Using two fingers press the touch point on the lower brace cover to release it from the lower brace.
134
Installing and removing system components
To Next Page
Loading...
