Next steps
1. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
2. Install the lower brace cover.
3. Reconnect all the cables onto the system board. For more information, see Cabling diagram.
4. Install the Risers.
5. Install the Storage tray.
6. Install the VSB cables on the system board.
7. Follow the procedure listed in the After working inside your system.
.
Sliding out the system board tray for NVIDIA GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the storage tray.
4. Remove the risers and keep the risers away from the system board tray and no need to disconnect the cables from the PSB.
5. Remove the VSB cables from the system board.
6. Remove lower brace cover.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
Steps
1. Unlock all the four blue plungers on the system board tray. Rotate the handle upward, and then lock the two blue plungers
near to the handle.
2. Slide the system board tray toward the rear of the chassis until it locks at its position.
Figure 148. Sliding out the system board tray
Next steps
Sliding in the system board tray for NVIDIA GPU configurations.
164
Installing and removing system components
To Next Page
Loading...
