Removing the GPU for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove the storage tray.
4. Remove the risers.
5. Remove the VSB cables from the system board.
6. Remove lower brace cover.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
9. Slide out the system board tray.
10. Unplug the cold plate tubes from the Manifold Liquid cooling module.
11. Remove the sensor tray.
12. Remove the GPU cold plate
Steps
1. If you want replace just the GPU module, using Torx 15, release four screws securing GPU module on GPU socket.
NOTE: All GPU cold plates are not required to be removed for replacing just one GPU.
2. Lift and remove the GPU module from the GPU socket.
NOTE: The procedure to remove the all the GPUs is same.
Figure 224. Removing the GPU module
Next steps
Replace the GPU.
Installing the GPU for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
212
Installing and removing system components
To Next Page
Loading...
