Next steps
.
1. Install the power supply units
2. Reconnect the cables connector on the PDB.
3. Install the VSB cables on the PDB.
4. Reconnect the liquid cooling tubes to the Manifold for the connectors 6, 7, 8.
5. Install the system board tray.
6. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
7. Install the lower brace cover.
8. Reconnect all the cables onto the system board. For more information, see Cabling diagram.
9. Install the Risers.
10. Install the Storage tray .
11. Install the VSB cables on the system board.
12. Follow the procedure listed in the After working inside your system.
Removing the CBB cold plate module for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove the storage tray.
4. Remove the risers.
5. Remove the VSB cables from the system board.
6. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
7. Remove lower brace cover.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
9. Slide out the system board tray.
Steps
1. Here is the orientation image for removal and installation sequence of liquid cooling tubes for processor, CBB, GPU cold
plates.
Figure 168. Removal and installation sequence of liquid cooling tubes for processor, CBB, GPU cold plates
2. Unplug the cold plate tubes numbering with 1 and 6 from the Manifold Liquid cooling.
180
Installing and removing system components
To Next Page
Loading...
