Figure 113. Removing the lower brace cover
Next steps
Replace the lower brace for Intel GPU configurations.
Installing the lower brace cover for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove the cable cover.
4. Observe and disconnect the intrusion switch cable from the storage tray that is connected from the system board.
Disconnect the drive backplane cables, BOSS power and signal cables, fan board cables from the connectors of the storage
tray and keep the cables away from the storage tray.
5. Remove the storage tray.
Steps
Align the lower brace cover on the lower brace along the arrow, using two fingers press the touch point on the lower brace
cover until it firmly seated on the lower brace.
Installing and removing system components
133
To Next Page
Loading...
