Dell PowerEdge XE9640 - Removing the GPU with GPU Cold Plate for Intel GPU Configurations

8. Install the VSB cables on the system board.
9. Follow the procedure listed in the After working inside your system.
.
Removing the GPU with GPU cold plate for Intel GPU
configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove the storage tray.
4. Remove the risers.
5. Remove the VSB cables from the system board.
6. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
7. Remove lower brace cover.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
9. Slide out the system board tray.
10. Unplug the cold plate tubes from the Manifold Liquid cooling module.
11. Remove the sensor tray.
Steps
1. Unplug the cold plate tubes from the Manifold Liquid cooling module. Pull the plunger and rotate the metallic gate . Using
Torx 15 screwdriver, release four screws securing GPU with GPU cold plates on GPU socket.
2. Lift and remove the GPU with GPU cold plates from the GPU socket.
NOTE: The procedure to remove the all the GPU with GPU cold plates is same.
Figure 204. Removing the GPU with GPU cold plates
200
Installing and removing system components