Installing the GPU board for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Remove the storage tray.
4. Remove the risers.
5. Remove the VSB cables from the system board.
6. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
7. Remove lower brace cover.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
9. Slide out the system board tray.
10. Remove the CBB cold plate module.
11. Unplug the cold plate tubes from the Manifold Liquid cooling module.
12. Remove the sensor tray.
13. If you want to replace the whole GPU board, remove the GPU and GPU cold plate.
Steps
1. Here is the orientation image for removal and installation sequence of liquid cooling tubes for processor, CBB, GPU cold
plates.
Figure 209. Removal and installation sequence of liquid cooling tubes for processor, CBB, GPU cold plates
2. Align and insert the GPU board in to the chassis. Using the Phillips 2 screwdriver, tighten the screws securing the GPU
board into the chassis. Reconnect the power cables on to the GPU board.
204
Installing and removing system components
To Next Page
Loading...
