Figure 25. Installing the cable cover
Next steps
Follow the procedure listed in the After working inside your system.
Fan board
This is a service technician replaceable part only.
Removing the cooling fan board for Intel GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the cooling fan modules.
4. Remove the cable cover.
5. Observe and disconnect the intrusion switch cable from the storage tray that is connected from the system board.
Disconnect the drive backplane cables, BOSS power and signal cables, fan board cables from the connectors of the storage
tray and keep the cables away from the storage tray.
Steps
1. Using the Phillips 2 screwdriver, remove the screws securing fan board to the storage tray. Holding the fan board, lift it away
from the system.
Installing and removing system components
69
To Next Page
Loading...
