Figure 282. Installing the GPU module
Next steps
1. Install the GPU cold plate.
2. Install the sensor tray.
3. Plug the cold plate tubes to the Manifold Liquid cooling module.
4. Slide in the system board tray.
5. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
6. Install the lower brace bracket.
7. Reconnect all the cables onto the system board. For more information, see Cabling diagram.
8. Install the risers.
9. Install the storage tray .
10. Install the VSB cables on the system board.
11. Follow the procedure listed in the After working inside your system.
Manifold module
This is a service technician replaceable part only.
Removing the Manifold module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. For NVIDIA configurations:.
● Disconnect the cables from the connector on the system board and the storage tray.
● Remove the VSB from the system board and keep it on the storage tray and no need to disconnect from the PDB2.
● Remove the storage tray.
● Remove the risers and keep the risers away from the system board tray and no need to disconnect the cables from the
PSB.
● Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
● Remove the lower brace bracket.
● Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and
make sure do not damage any connectors on the system board.
Installing and removing system components
251
To Next Page
Loading...
