Sliding in the system board tray for NVIDIA GPU configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the storage tray.
4. Remove the risers and keep the risers away from the system board tray and no need to disconnect the cables from the PSB.
5. Remove the VSB cables from the system board.
6. Remove lower brace cover.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
Steps
1. Hold the system board tray handles, slide it toward front of the chassis until the tray firmly locks in its place.
2. Unlock the two blue plungers near to the handle to release the handle. Rotate the handle and slide the system board tray
again to lock in its position. Release the handle until it firmly locks into the chassis. Lock the four blue plungers.
Figure 149. Sliding in the system board tray
Next steps
1. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
2. Install the lower brace cover.
3. Reconnect all the cables onto the system board. For more information, see Cabling diagram.
4. Install the Risers.
5. Install the Storage tray .
6. Install the VSB cables on the system board.
7. Follow the procedure listed in the After working inside your system.
.
Installing and removing system components
165
To Next Page
Loading...
