Figure 264. Installing the GPU board
Next steps
1. Install the GPU and GPU cold plates.
2. Install the sensor tray.
3. Plug the cold plate tubes to the Manifold Liquid cooling module.
4. Slide in the system board tray.
5. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
6. Install the lower brace bracket.
7. Reconnect all the cables onto the system board. For more information, see Cabling diagram.
8. Install the risers.
9. Install the storage tray .
10. Install the VSB cables on the system board.
11. Follow the procedure listed in the After working inside your system.
Removing the GPU cold plate for NVIDIA configurations
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system .
3. Disconnect the cables from the connector on the system board and the storage tray.
4. Remove the VSB from the system board and keep it on the storage tray and no need to disconnect from the PDB2.
5. Remove the storage tray.
6. Remove the risers and keep the risers away from the system board tray and no need to disconnect the cables from the PSB.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Remove the lower brace bracket.
9. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
240
Installing and removing system components
To Next Page
Loading...
