3. Install the handles on the CBB to remove the CBB away from the chassis. Using the Phillips 2 screwdriver, tighten the
screws to secure the handles on the CBB.
NOTE: The CBB handles are not preinstalled into the system. The handles are part of the CBB kit.
Figure 169. Installing the handles on the CBB
4. Using the Phillips 2 screwdriver, remove the screws securing on the CBB cold plate module. Using both the hands, lift the
CBB away from the GPU board.
Figure 170. Removing the CBB cold plate module
Installing and removing system components
181
To Next Page
Loading...
