NOTE: Ensure to hold the retaining clip to the DLC module as you lift the TIM break lever.
Figure 119. Removing the processor
NOTE: Ensure to return the TIM break lever back to original position.
4. Using your thumb and index finger, first hold the retaining clip release tab at the pin 1 connector, pull out the tip of the
retaining clip release tab, and then lift the retaining clip partially from the DLC module.
5. Repeat the procedure at the remaining three corners of the retaining clip.
6. After all the corners are released from the DLC module, lift the retaining clip from the pin 1 corner of the DLC module.
Installing and removing system components
139
To Next Page
Loading...
