2. Follow the procedure listed in Before working inside your system.
3. Remove the storage tray.
4. Remove the risers and keep the risers away from the system board tray and no need to disconnect the cables from the PSB.
5. Remove the VSB cables from the system board.
6. Remove lower brace cover.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
8. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
Steps
1.
NOTE: Make sure the two blue plungers at the rear of the chassis are unlocked and two blue plungers near to the
system board handle are in locked position with handle upward.
NOTE: Make sure chassis inner slide up_down triangle mark is fully aligned with chassis triangle mark.
Using both the hands, one hand holding the handle and another one holding the system handle, align system board tray
alignment slot into T-standoffs on chassis.
Figure 153. Alignment position
2. Hold the system board tray, slide it toward front of the chassis until the tray firmly locks in its place.
3. Unlock the two blue plungers near to the handle and the handle firmly locks into the chassis.
168
Installing and removing system components
To Next Page
Loading...
