Steps
1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
3. Using a Phillips 2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
Figure 158. Installing the LOM card
Figure 159. Installing the rear I/O board
Next steps
1. Install the system board.
2. Observe and connect the cables to the connectors on the power distribution board.
3. Follow the procedure listed in After working inside your system.
172
Installing and removing system components
To Next Page
Loading...
