Steps
1. Using the Phillips 2 screwdriver, remove the screws securing the plastic cable holder from the PSB.
Figure 239. Removing the cable holder
2. To disengage the PSB from the GPU board connectors, follow the steps that are mentioned below:
a. Lift the GPU assembly handle to disengage the GPU tray clips.
b. Lift the clips to release them from the clip holders.
c. Ensure that the clips are free and lower the GPU assembly handle.
Figure 240. Unlocking the GPU assembly handle
3. Using the Phillips 2 screwdriver, remove the screws securing the PSB on the chassis. Lift the PSB away from the chassis.
224
Installing and removing system components
To Next Page
Loading...
