Figure 256. Removal and installation sequence of liquid cooling tubes for processor, PSB cold plate, GPU cold
plates
2. Align and insert he GPU with GPU module on the GPU socket. Using Torx 15 screwdriver, tighten the four screws securing
GPU with GPU module on GPU socket. Plug all the liquid cooling tubes from all the GPU cold plates to the Manifold.
NOTE: The procedure to install all the GPU with GPU modules is same.
Figure 257. Installing the GPU with GPU module
Next steps
1. Install the sensor tray.
2. Plug the cold plate tubes to the Manifold Liquid cooling module.
Installing and removing system components
235
To Next Page
Loading...
