e. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling diagram.
f. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and
make sure do not damage any connectors on the system board.
g. Slide out the system board tray.
h. Unplug the cold plate tubes from the Manifold Liquid cooling module.
Steps
1. First insert the hot tube into the holder and push manifold toward front of the chassis. Using the Torx 15 screwdriver,
tighten the screws to secure on the manifold at the front of the chassis. Then insert the cold tube in the holder.
2. Using the Torx 15 screwdriver, tighten the screws to secure on the manifold at the front of the chassis.
Figure 285. Tighten the screws
254
Installing and removing system components
To Next Page
Loading...
