Table 46. NVMe-oF SubSystem n Settings(continued)
Option Description
NVMe-oF subsystem NID Specifies the NamespaceID (NID) for this NVMe-oF connection.
NVMe-oF subsystem Controller ID Specifies the NVMe-oF subsystem's Controller ID for this connection. This option
is set to 0 by default.
Security Enables or disables the security option for this NVMe-oF connection. This option is
set to Disabled by default.
Authentication Type Specifies the authentication type for this NVMe-oF connection. This option is set
to None by default.
Securitykeypath Specifies the Securitykeypath for this NVMe-oF connection.
Integrated Devices
To view the Integrated Devices screen, power on the system, press F2, and click System Setup Main Menu > System BIOS
> Integrated Devices.
Table 47. Integrated Devices details
Option Description
User Accessible USB Ports Configures the user accessible USB ports. Selecting Only Back Ports On
disables the front USB ports; selecting All Ports Off disables all front and
back USB ports.; selecting All Ports Off (Dynamic) disables all front and back
USB ports during POST. and front ports can be enabled or disabled dynamically
by authorized user without resetting the system. This option is set to All Ports
On by default.
The USB keyboard and mouse still function in certain USB ports during the
boot process, depending on the selection. After the boot process is complete,
the USB ports will be enabled or disabled as per the setting.
iDRAC Direct USB Port The iDRAC Direct USB port is managed by iDRAC exclusively with no host
visibility. This option is set to ON or OFF. When set to OFF, iDRAC does not
detect any USB devices installed in this managed port. This option is set to On
by default.
Integrated Network Card1 This option is seen only if OCP is installed. Enables or disables the integrated
network card. When this option is set to Enabled, the card is not available to
the operating system. This option is set to On by default.
NOTE: If set to Disabled (operating system), the Integrated NICs might
still be available for shared network access by iDRAC.
Embedded NIC1 and NIC2
Enables or disables the OS interface of the Embedded NIC1 and NIC2
controller. If set to Disabled (OS) , the NIC may still be available for shared
network access by the embedded management controller.
Configure the Embedded NIC1 and NIC2 option by using the NIC
management utilities of the system. This option is set to Enabled by default.
I/OAT DMA Engine Enables or disables the I/O Acceleration Technology (I/OAT) option. I/OAT is
a set of DMA features designed to accelerate network traffic and lower CPU
utilization. Enable only if the hardware and software support the feature. This
option is set to Disabled by default.
Embedded Video Controller Enables or disables the use of Embedded Video Controller as the primary
display. When set to Enabled, the Embedded Video Controller will be the
primary display even if add-in graphic cards are installed. When set to
Disabled, an add-in graphics card is used as the primary display. BIOS will
output displays to both the primary add-in video and the embedded video
during POST and preboot environment. The embedded video will then be
Pre-operating system management applications 45
To Next Page
Loading...
