Delta AX Series

AX-Series Motion Controller Instructions Manual Chapter 2
2-258
 When the Enable of DMC_GroupJog is True, the Forward[0]~ Forward[2] pins are activated, and the axis will
start to run to the MaxDistance setting position and then stop running.
 When any axis in the axis group is running, bActive of DMC_GroupJog is True. bActive is False after the axis
group is running.
Axis_1_Position
Axis_2_Position
Axis_3_Position
2000
3000
DMC_GroupJog
Enable
Forward[0]
Forward[1]
Forward[2]
bBusy
bActive
1000