Delta AX Series User Manual

AX-Series Motion Controller Instructions Manual Chapter 2
393
 Enter the name of the axis group that you want to enable, and then run DMC_GroupPower.bRegulatorOn. When
bStatus turns to True, all single axes in the axis group have been enabled.

Delta AX Series Specifications

General

Input Voltage	24 VDC
Expansion Modules	Up to 8 modules
Series	AX
Operating Temperature	0°C to 55°C
CPU	32-bit
Communication Ports	RS-232, RS-485, Ethernet
Type	Programmable Logic Controller (PLC)
Programming Language	Ladder Diagram
I/O Capacity	Up to 256 I/O points