Delta AX Series User Manual

AX-Series Motion Controller Instructions Manual Appendix A
544
Error code Description Contents Corrective Action
0x1885C
DMC_GM_AXIS_GROUP_VELOCITY
_EXCEED_
LIMIT
The velocity of axis group
exceeds the limit set in the
parameter setting.
1. Execute MC_GroupReset to
make the group state back to
GroupStandby.
2. Make sure the group velocity
does not exceed the limit set in
the parameter setting.
3. Re-run the function block.
0x1885D
DMC_GM_AXIS_GROUP_ACCELER
ATION_
EXCEED_LIMIT
The acceleration of axis group
exceeds the limit set in the
parameter setting.
1. Execute MC_GroupReset to
make the group state back to
GroupStandby.
2. Make sure the group
acceleration does not exceed
the limit set in the parameter
setting.
3. Re-run the function block.
0x1885E
DMC_GM_AXIS_GROUP_DECELER
ATION_
EXCEED_LIMIT
The deceleration of axis group
exceeds the limit set in the
parameter setting.
1. Execute MC_GroupReset to
make the group state back to
GroupStandby.
2. Make sure the group
deceleration does not exceed
the limit set in the parameter
setting.
3. Re-run the function block.
0x1885F
DMC_GM_AXIS_GROUP_JERK_EX
CEED_LIMIT
The jerk of axis group exceeds
the limit set in the parameter
setting.
1. Execute MC_GroupReset to
make the group state back to
GroupStandby.
2. Make sure the group jerk does
not exceed the limit set in the
parameter setting.
3. Re-run the function block.
0x18860
DMC_GM_AXIS_GROUP_PLANNIN
G_ERROR
Axis group planning error.
1. Execute MC_GroupReset to
make the group state back to
GroupStandby.
2. Make sure the parameters set
for the motion instruction are
reasonable for planning paths.
3. Re-run the function block.
0x18861
DMC_GM_AXIS_GROUP_MOVE_ER
ROR
Axis group move error.
1. Execute MC_GroupReset to
make the group state back to
GroupStandby.
2. Make sure the parameters set
for the motion instruction are
reasonable for planning paths.
3. Re-run the function block.
0x18862
DMC_GM_CMD_BUF_
FULL
Command buffer is full.
1. Make sure there’s still some
space in the command buffer.
2. Re-run the function block.

Delta AX Series Specifications

General

Input Voltage	24 VDC
Expansion Modules	Up to 8 modules
Series	AX
Operating Temperature	0°C to 55°C
CPU	32-bit
Communication Ports	RS-232, RS-485, Ethernet
Type	Programmable Logic Controller (PLC)
Programming Language	Ladder Diagram
I/O Capacity	Up to 256 I/O points