Intelligent Tool Control (ITC) Function Settings
This machine is equipped with the Intelligent Tool Control (ITC) function. By setting the ITC function, you can
automatically replace milling burs that reach their replacement time during use with the next milling bur. This
makes it possible to continue milling for a long time without any loss in milling quality. You can use this window
to set the combinations of milling burs that will be switched automatically.
You can specify milling burs as a single set by registering the milling burs with the same name. In a single set
consisting of the same type of milling burs, you can specify a maximum of three milling burs and a minimum of
two milling burs.
Specifying three milling burs as a single set
Set three milling burs with the same name in the milling bur stocker.
Specifying two milling burs as a single set
Set two milling burs with the same name in the milling bur stocker.
VPanel Window and Functions
22
Chapter 1 Basic Operation
To Next Page
Loading...
